Our stickers are of high quality. They are printed in high resolution and are suitable for use in vehicles and are car wash-proof. Of course, they can also be used indoors.
Small stickers and oil slick stickers can be applied dry and large stickers and foils should be applied wet. The sticker (only for foil plots) must be squeegeed again on both sides with a felt squeegee or another tool (e.g. an EC card wrapped in a cloth) before the thicker carrier foil is removed from the thinner transfer foil. The surface to be glued must be free of dust, grease or other contaminants that could impair the adhesive strength of the material. New paintwork must be dried or completely hardened for at least three weeks. The bonding temperature should be => 10°C. This temperature should also be maintained as a minimum after bonding. The sticker has achieved its full adhesive strength approx. 3 days after bonding. It is suitable for car washes approx. 2 weeks after bonding. When cleaning with a high-pressure nozzle, please work at a distance of 50 cm. The permanent exposure to a windshield wiper reduces the lifespan of the sticker.
Smaller stickers can be applied dry without any problem under the conditions mentioned above. Oil slick stickers should also be applied dry. The sticker (only for foil plots) must be squeegeed again on both sides with a felt squeegee or another tool (e.g. an EC card wrapped in a cloth) before the thicker carrier film is removed from the thinner transfer film. This means that the thicker carrier film is removed from the thinner transfer film (the sticker is stuck to this).
The sticker can now be stuck to the desired location. After gluing, the sticker with the transfer film should be rubbed over again with a cloth or squeegee. Then wait about 10 minutes before removing the transfer film from the sticker to avoid bubbles forming and the sticker getting stuck on the transfer film.
